Piri T

Description

Automatic sorting system dedicated to oil seals and similar parts.

The pieces will be loaded one after the other on the conveyor belt and then separated, in different bins, into good parts (in the tolerance range) and scraps, at the end of each inspection cycle.

The operator chooses the area to inspect and the relative parameters for each camera.

Tipo di controllo

• Surface inspection
• ID/OD
• Cuts
• Porosity
• Flow lines
• Lack of material
• Tears

M1=Inspection of the sealing lip of the oil seal
M2=upper surface inspection"check the presence of the spring" .
M3=Lower surface Inspection “check back-ring”
M4=Outside lateral surface inspection
M5=Diameter measurement, check flashes, concentricity, ovalization.